NX-148E-RF LCD Touchpad w ith Receiver Installation Instructions 5
4. Enter the zone location and press #. For example, enter
407 # to delete zone 7.
5. To change transmitter feature 1 (Transmitter enabled),
enter 1 and press *. The 1 turns off to indicate the feature
change.
6. To delete additional transmitters, repeat steps 3 to 5.
Note: To delete all transmitters and load factory defaults,
enter 910 #.
7. To exit program mode, press EXIT EXIT.
Transmitter testing and troubleshooting
Test all transmitters to verify correct programming and
operation. Location 600 gives the number of rounds of the last
transmitter learned in. A minimum of 7 to 8 transmissions is
required for all transmitters. If the number of transmissions is
less than the minimum required, supervisories can occur.
Rotate the mounting position (90, 180, or 270 degrees) of any
transmitter that consistently tests below margin and retest.
If rotating the transmitter mounting position does not improve
signal reception or is not practical, move the transmitter to
different locations near the preferred mounting area. Test each
location until the transmitter consistently tes ts good, then
mount the transmitter.
Touchpad programming
To program the touchpad, do the following:
1. Press * and enter the function number to select the
desired function. Table 4 lists the programming
information for each function.
Note: Press * repeatedly to scroll through available
functions
Table 4. Touchpad functions
Adjust view /brightness of LCD
Set touchpad number and partition
Set elapsed time (in minutes) since last
autotest
Seize phone line for dow nload
2. To exit the function menu, press #.
Adjust touchpad tone (0)
To raise or lower the tone on the touchpad, do the following:
1. Enter * 0.
2. Press or to raise or lower the tone. The touchpad will
emit a continuous tone, allowing you to hear the selection.
3. To save the tone and exit, press #.
Temporary master mode (1)
The master mode of operation allows you to temporarily
access any partition (providing your code is authorized) within
the system and to do functions in other partitions. The keypad
will revert back to its assigned partition 60 seconds after a key
press, or 10 seconds without a keypress. To set a temporary
master mode, do the following:
1. Enter * 1.
2. Enter your user code.
3. To exit, press #.
View zone status (p)
To view zone status, do the following:
1. Press * .
2. Press or to scroll through the list. The list shows all
zones in sequential order by zone number.
3. To exit, press #.
Comments to this Manuals