Interlogix NX-148E-RF User Manual download pdf (Page 8)

8 NX-148E-RF LCD Touchpad w ith Receiver Installation Instructions

Table 7. Editing character data

Command

Action

Saves character or word. Moves cursor to the right.

CANCEL

Moves cursor to the left.

Scrolls through available characters. In library mode,

scrolls through available w ords.

STAY

Inserts a black space.

CHIME

Deletes characters.

EXIT

Accesses the library page.

BYPASS

Makes the character flash. If you are in library mode, it

w ill make the entire w ord flash.

Exits.

Set touchpad options (93)

To set touchpad options, do the following:

1. Press * 93.

2. Enter your program code.

3. Follow the instructions on the bottom line of the display to

select the options you want (see Table 8). If you do not

want to change an option, press * to advance to the next

option.

4. To exit, press #

Table 8. Touchpad options

Option

Touchpad features

Not used

Silent touchpad - Enables silent touchpad option. If

enabled, only the entry/exit and sounder chime are

silenced.

Ding dong chime - Enable the ding dong sound for chime.

5 second silence - Silences the pulsing touchpad sounder

for 5 seconds w hen a key is pressed.

Armed zone info - Touchpad w ill display faulted or

bypassed zone information w hen the system is armed.

Beeps on panics - Will sound a short beep w hen the

keypress is accepted.

Disable service - Suppresses the Service message.

Master touchpad - Enables multi-partition mode.

Custom message - Enables custom message display.

Clock - Enables clock display.

Custom message lock - Prevents over-writing the custom

message during touchpad copy.

Select an option - Programs special characteristics.

1 = Display Press * For Help

2 = Disable LED extinguish on this touchpad

3 = On if PIN should be hidden w hen programming

4 = On suppresses beeps when an RF Transmission is

lost.

5-8 = Reserved (do not program)

Set elapsed time since the last autotest (95)

To set the elapsed time (in minutes) since the last autotest, do

the following:

1. Enter * 95.

2. Enter your program code.

3. Enter the elapsed time in minutes using three digits. For

example, enter 005 for 5 minutes.

4. To exit, press #.

Set system time and date (97)

To set the system time and date, do the following:

1. Enter * 97.

2. Enter your program code.

3. Press or to scroll for the proper hour.

4. Press * to advance to the next selection (minutes).

5. Repeat steps 3 and 4 until the time and date are set.

6. To exit, press #.

Call back for download (98)

To cause the control to do a call back for download (while the

system is disarmed), enter * 98.

Seize phone line for download (99)

To cause the control to seize the phone line for a download

(while the system is disarmed), enter * 99.

Walk test (CHIME)

The walk test allows you to walk through to test the zones

(while the system is disarmed). To do a walk test, do the

following:

1. Enter * CHIME.

2. Enter your user code.

3. Walk through the zones. Each time a zone is faulted, it will

be displayed on the touchpad and a chime will sound.

4. The walk test mode will exit after 15 minutes, or you can

enter your user code to exit at anytime.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Interlogix NX-148E-RF User Manual Page 8

Comments to this Manuals

Related products and manuals for Safety Interlogix NX-148E-RF