Interlogix DVR 11 User Manual User Manual download pdf (Page 44)

5BChapter 6: Network settings

38 TruVision DVR 11 User Manual

To configure SNMP protocol settings:

1. Click the Network settings icon in the menu toolbar.

2. Click SNMP and enter the required settings.

3. Click Apply to save the settings.

Configuring a remote alarm host

If a remote alarm host set, the DVR sends a signal to the host when an alarm is

triggered. The remote alarm host must have the TruVision Navigator server

software installed.

To set up a remote alarm host:

1. Click the Network Settings icon in the menu toolbar.

2. Click More Settings.

3. Enter Alarm Host IP and Alarm Host Port.

Alarm host IP represents the IP of the remote PC where the Network Video

Surveillance software installed. The alarm host port value must be the same

as software’s alarm monitor port. Default port is 7200.

4. Click Apply to save the settings.

Configuring multicast

Setting up multicasting resolves limitation issues when streaming videos through

a network access device. A multicast address spans the Class-D IP range of

224.0.0.0 to 239.255.255.255. We recommend that the IP address range of

239.252.0.0 to 239.255.255.255 be used.

To set up multicasting:

1. Click Network Settings icon in the menu toolbar and then click More

Settings.

2. Enter a Multicast IP address.

Note: When adding a device to the Network Video Surveillance software, the

multicast address must be the same as the DVR’s multicast IP.

3. Click Apply to save the settings.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 155 156

No comments

Interlogix DVR 11 User Manual User Manual Page 44