Interlogix Simon XT User Manual User Manual download pdf (Page 27)

Simon XT User Manual 21

• Communication troubles with the central monitoring station

When your security system detects one of the problems above, six rapid beeps

sound every minute until the trouble condition is corrected. To stop the trouble

beeps, press STATUS or arm/disarm the system while the trouble condition

exists. Trouble beeps will resume four hours later unless the trouble condition is

corrected.

The following list explains the trouble beep conditions:

AC power failure

This condition (if programmed by installer) occurs if your security system has

been accidentally unplugged or if there has been an AC power outage. Any

status lights go out immediately, and trouble beeps start after five minutes. If you

press any button, the display will light and pressing STATUS will show the AC

failure. If AC power is not restored within a programmed period of time (5 to 254

minutes) the system will call the central monitoring station. The backup battery, if

fully charged, will last for 18 to 24 hours—depending on the load applied to the

panel—with no AC power.

In a UL installation, a new, fully charged backup battery will last 24 hours with the

panel in normal standby condition and still sound an alarm.

System battery failure

This condition occurs if the emergency backup battery has failed. Trouble beeps

will start. Press the STATUS button and the display will show System Low

Battery. If your AC power is not working, your security system will shut down

once the battery has failed. If the condition does not clear after AC power has

been restored and 24 hours have passed, call your security system dealer.

Restoration of power

This condition occurs after a complete loss of power (AC and battery). When

power is restored, the panel will return to the arming state with the same zones

bypassed it had prior to losing power.

Sensor failure

This condition occurs if a sensor is not communicating with the panel. Trouble

beeps will start and the STATUS button will light. Press the STATUS button and

the display will show what sensors have failed. Perform sensor tests. You may

need to call your security system dealer if the problem continues.

Sensor low battery

This condition occurs if a system sensor has a low battery. The sensor may still

be communicating with the panel. Trouble beeps will start and the STATUS

button will light. Press the STATUS button and the display will show what

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 49 50

No comments

Interlogix Simon XT User Manual User Manual Page 27