Interlogix NX-148E User Manual download pdf (Page 26)

NX-148E LCD Keypad

DISPLAY DESCRIPTION

Cancel Cancel System is disarmed and the Cancel button was

pressed within 5 minutes of an alarm.

Gnd Flt Ground Fault A short to ground has been detected.

Man Test Manual Test Bell and/or communicator test while system is in

disarmed condition.

Re-exit Re-Exit The exit delay has been re-started without

disarming the system.

Output Trip Output Trip A trip has occurred on an expander auxiliary

output.

Data Lost Data Lost Communication of a signal has failed (log only

event).

Walk-test Walk-Test A zone “Walk-Test” mode has been activated.

End Test End Test Test has been ended.

Cross-Trip Cross Trip The first zone of a cross zone has been tripped (log

only).

Expansion

Event

Expansion Event An expansion module created an undefined event.

Partial Arm Partial Arm Reports a closing in the stay mode.

Listen In Listen In A listen in function has been activated.

Service Start Service Start Technician is on site.

Service End Service End Technician is off site.

Code Entry Code Entry A code has been entered.

First Open First Open Reports when the first partition is disarmed.

Last Close Last Close Reports when the last partition is armed.

Sprnklr Sprinkler Instant sprinkler supervisory report

Clock Set Clock Set Clock has been reset.

RF Jammed RF Jammed A wireless expansion module is jammed

CleanMe CleanMe A smoke detector requires cleaning.

1 2 ... 21 22 23 24 25 26 27 28 29 30

No comments

Interlogix NX-148E User Manual Page 26