P/N 1072666A-EN • REV 1.0 • ISS 24SEP13 TruVision IP PTZ Camera Installation Guide
10 Installation Guide 10. Install the trim ring. Align the trim ring to the housing, and insert the fix-pins to the holes. Then rotate the ring clo
Installation Guide 11 1. Use the mounting base as a template to mark four screw holes onto the ceiling. If you route cables from the top of the hou
12 Installation Guide 6. Install the housing onto the mounting base. Line up the direction of the arrow on the housing with the spring end of the mo
Installation Guide 13 8. Re-attach the bubble by screwing it to the housing. Warning: After installation, the PTZ module will perform a PTZ sel
14 Installation Guide Using the camera with an Interlogix NVR or Hybrid DVR or another system Please refer to the NVR/DVR user manuals for instructio
Installation Guide 15 3. Click the Configuration tab on the top of the screen and select the parameter to change Figure 2: Example of a configuratio
16 Installation Guide Configuration folders Description Storage Defines recording schedule, storage management and NAS configuration. . Specificati
Installation Guide 17 Pin definitions There are eight wires on a standard UTP/STP cable and each wire is color-coded. The following shows the pin al
18 Installation Guide
Copyright © 2013 UTC Fire & Security Americas Corporation, Inc. Interlogix is part of UTC Climate Controls & Security, a unit of United T
Installation Guide 3 Content Introduction 3Product overview 3Before you begin 4Installation environment 4Camera description 5Installi
4 Installation Guide TVP-1101 (1.3MPX pendant, PAL) TVP-3101 (1.3MPX pendant, NTSC) TVP-1102 (1.3MPX surface, PAL) TVP-3102 (1.3MPX s
Installation Guide 5 Camera description Figure 1: Overview of the dome camera (pendant-mount shown) 1. Power supply cord Connect 24 VAC power supp
6 Installation Guide Installing a camera Pendant-mount camera 1. Prepare the mounting surface and install the camera bracket. 2. Unscrew the bubble
Installation Guide 7 Safety cable Note: If alarm and audio input/output relays are to be used, also connect them to the PCB of the module. Cauti
8 Installation Guide 9. See “Accessing the camera over the internet” on page 14 to configure the camera over the internet. Refer to the Configuratio
Installation Guide 9 6. Adjust the height of the two housing tabs by turning the screw on which they are attached. The distance (h) of the tabs fro
Comments to this Manuals