Interlogix TruVision 960H Premium Resolution Series PTZ Camer User Manual download pdf (Page 23)

Chapter 2: Programming

TruVision Analog PTZ Camera Configuration Manual 21

You can clear the defined limit stops. Click IRIS+ to enter CLEAR STOPS and

click IRIS+ again to clear the stops.

Elevation set

You can enable the elevation angle of the PTZ camera. You can set ELEVATION SET to ON or OFF.

Presets

A preset is a user-defined monitor position/point. You can simply call the preset number to

change the monitor scene to the defined position. See Figure 7 below.

Figure 7: Preset menu

To set a preset:

1. Go to MAIN MENU > SYSTEM SETTINGS > PRESETS

2. Move the cursor to PRESET NUMBER and click IRIS+ to enter. Click the up and down

buttons to select the preset number to be configured. If the preset has been defined, the

preset label is listed under the number. If it has not been defined, UNDEFINED is

displayed under the number.

Note: The system-defined presets are displayed on this submenu but they cannot be

changed.

3. Select the preset number.

To edit a preset label:

1. Go to MAIN MENU > SYSTEM SETTINGS > PRESETS

2. Move the cursor to EDIT LABLE and click IRIS+ to enter the edit mode.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 37 38

No comments

Interlogix TruVision 960H Premium Resolution Series PTZ Camer User Manual Page 23