Interlogix TVD-TIR6 User Manual download pdf (Page 14)

EN 12

6. Connect a 75 ohm coaxial video cable to the

camera’s video cable, and connect a 12 VDC

(TVD-TIR6-SR(-P)) or 12 VDC/24 VAC (TVD-

TIR6-MR/HR(-P)) power supply to the power

cable.

7. Check the picture and adjust the camera

position and angle as required.

Note: When installing a TVD-TIR6-MR(-P) or TVD-

TIR6-HR(-P) camera, tilting the camera

housing past 80° may result in reflection of IR

illumination from the camera base into the lens.

This can distort or obscure the picture in night

mode.

8. Tighten the shroud screws to secure it to the

mounting bracket. Ensure that the camera

shroud is firmly attached to the bracket.

9. If necessary, use a flat blade screwdriver to

adjust the zoom first, and then the focus (see

Figure 3 on page 7).

10. Put the rubber plug into the focus and zoom

holes to prevent water and moisture getting

inside.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 75 76

Comments to this Manuals

No comments