Interlogix TVW-2101 User Manual User Manual download pdf (Page 6)

6 TruVision Analog Wedge Camera

Setting up the camera

Note: If the light source where the camera is installed experiences rapid, wide-

variations in lighting, the camera may not operate as intended.

To quickly put the dome camera into operation:

1. Prepare the mounting surface.

2. Connect the power cable and video cable to the camera. See “Connecting

the devices” below.

3. Mount the camera to the ceiling using the appropriate fasteners. See

“Mounting the wedge camera” below.

4. Set up the camera’s image parameters. See “Configuring the wedge

camera” on page 8.

Connecting the devices

A qualified service person, complying with all applicable codes, should perform

all required hardware installation.

Figure 2: Connections on the base of the wedge cameras

1. Power supply

Connect 12 VDC power supply.

2. BNC port

Connect to DVR or monitors.

Mounting the wedge camera

1. Use the supplied template to mark out the mounting area. Drill the screw

holes on the ceiling.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Interlogix TVW-2101 User Manual User Manual Page 6